FG approves establishment of Bola Tinubu Polytechnic in Abuja

The federal government has approved the establishment of a federal polytechnic in Abuja to be named after President Bola Tinubu.

Tunji Alausa, the minister of education, confirmed this in a letter addressed to Nyesom Wike, the FCT minister, on January 9.

Alausa said establishing the institution is part of the ministry’s plan to ensure every state has a federal polytechnic.

The minister said the project aligns with the government’s policy to promote technological and vocational training.

The letter asked the FCT minister to suggest suitable locations in Gwarinpa for both the polytechnic’s temporary and permanent sites.

Alausa said a technical team from the ministry of education and the National Board for Technical Education (NBTE) is expected to inspect

He added that the government is open to taking over existing tertiary institutions in the FCT if they meet the requirements for the new polytechnic.

Earlier, the NBTE inaugurated a foundation to revitalise polytechnic education in Nigeria.

Idris Bugaje, the NBTE’s executive secretary, said there is a need to address some pressing challenges facing polytechnics.

He said plans are in motion to strengthen institutional capacity, promote industry collaboration, and facilitate international partnerships.

“Our polytechnic system must be the engine that drives Nigeria’s economic development and industrial growth,” the NBTE executive secretary said.

  • Related Posts

    NYSC: Education minister advocates extending national service to two years

      The National Youth Service Corps (NYSC) says the education ministry proposes the extension of the scheme’s duration to two years. The NYSC, in a statement by its public relations…

    JAMB uncovers 142 Kano varsity applicants with fake results

      The Joint Admissions and Matriculation Board has uncovered that out of 148 A-level results presented to Bayero University Kano for Direct Entry admission, only six were valid, leaving 142…

    Leave a Reply

    Your email address will not be published. Required fields are marked *